iPECS UCP600 - Page 167

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
153
System Act on Slave
Alarm Notification on CPU Redundancy is Act on Slave UCP
 Slave/Act - Slave UCP Activated: Alarm and Email
 Master/Act - Master UCP Activated: Email
WEB API SMDR Full
This entry enables the user to get the notification as an alarm when WEB API
SMDR is over the capacity.
Online License
This entry enables the user to get the notification as an alarm when online license
checking is failed. (vUCP only)
Timeslot Full
This entry enables the user to get the notification as an alarm when the timeslot is
full-on eMG800.
Below alarm notify condition can be set for each alarm type.
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Internal Noti.
Alarm Ring
Alarm ring to alarm ring enabled stations.
Alarm enabled stations: system-attendant, Alarm / Door Bell
Enabled Stations, Emergency Call Notification Stations, DCOB
Fault Notify Station, Stations who have Alarm Ring Coverage
button(s)
Alarm coverage button assignment: [Trans/PGM] + Flex button + 76
+ ## + Alarm Type(0-22)
Alarm Type : All(0), Emergency(1), DCO Fault(2), SIP Reg Fail(3),
BATH(4), DOOR-Bell(5), Alarm-Bell(6), Station Overflow(7),CO
Overflow(8), SMDR(9), VM FULL(10), WTIM Base fail(11), WTIM
Chain fail(12), I-SMDR full(13), CABINET alarm(14), BAR full(15),
IPCR fault(16), IPWATCH fail(17), Temp License Expire(18),
License Expire(19), License Overflow(20),TNET License
Expire(21), TAPI fail(22), PMS fail(23)
ON/OFF
ON
Internal Noti.
Alarm Ring
To stop an alarm: alarm stop is supported only by alarm ringing
station or external called party after answer. So, at least one station
for internal alarm ring needed to be assigned, and "Internal Noti.
Alarm Ring = ON" is strongly suggested currently
 By dial "alarm reset" code on a station that has the alarm ring
 By press the "stop" soft button on a station that has the alarm
ring
 By press, the "alarm coverage" button and select '1(me)/0(all)'
on a station that has the alarm ring
 By dial [alarm reset code] by an external party after answer
the alarm ring
ON/OFF
ON
Internal
Noti.Annc No.
Play & Repeat VSF announcement when a station answers an
alarm-to-internal ring.
0(not assign), 1-200
Refer to
description
0
External Noti.
Annc No.
Play & Repeat VSF announcement when an external party answers
an alarm-to-external ring. Even without a valid announcement, an
external ring is implemented.
0(not assign), 1-200
Refer to
description
0
External Noti.
Initial Delay
Duration of delay before external ring starts
0(immediate), 1-3600 sec
Refer to
description
0