iPECS UCP600 - Page 169

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
155
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Page Noti.
Page Repeat
Interval
Interval of paging repeat
0-255
10
Page Noti.
Annc Repeat
Count
Repeat count play announce per one repeat of paging
Total Play count : default(1) + repeat count(0-99)
0-99
2
Page Noti. Next
Prio. on
Failover
Option for a condition to start of failover scenario to next priority
(from 0 to 39)
 Immediately Go To Next: immediately implement next(less)
priority at the first busy status of previous(prior) paging
 After Retry All Counts: implement next(less) priority after
previous(prior) paging are all (re)tried and stopped by
failure(busy)
Refer to
description
Immediate
ly go to
next
Page Noti. Next
Prio. after Page
Normally failover scenario is not implemented anymore if a page to
a group is played to an external page or listened to by at least one
station internally. But if this timer is set(1-3600 sec.), the failover
scenario is started/resumed after this duration, even after
successfully paging.
0(immediate), 1-3600 sec
Refer to
description
0