iPECS UCP600 - Page 172

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
158
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Scenario
Priority
‘0’ is highest, ‘9’ is the lowest priority
For single destination: anything of 0-9 (meaningless)
For multiple destinations for simultaneous ring: same priority value
For failover (busy/error/unanswered) scenario: different priority
0-9
0 is highest
0
Telephone
Number
Mandatory input
Without this, no service
Max.32
character
Comment
Just for memorization by naming
Max.64
character
No Answer
Timer
Unanswered duration of the external call, after this timer, the
external is disconnected if not answered
30-180
second
30
Retry on Busy
Retry to make the external call if a busy cause disconnects calling.
If the called party system serves 'busy prompt' after connecting the
call, it is not regarded as the busy cause but as answered.
Yes
No
Yes
Retry on No
Answer
Retry to make the external call if the call is disconnected after 'No
Answer Timer.'
Yes
No
Yes
Retry Count
In addition to the first trial, the system will call until these counts on
fail (busy/error/unanswered) condition.
1-9
2
Retry Interval
Pause duration per a retrial
30-180
second
30
Weekday
Monday to Sunday
All, MON, TUE, WED, THU, FRI, SAT, SUN
Refer to
description
All
Service Time
'start time' to 'end time' (start time can be longer than end time, etc.
2300 - 0559)
0000-2359
0000-2359
Service for
Alarms
Selection of alarm types to serve by this table
Mandatory input
Without the selection of an alarm type, the alarm type is served