iPECS UCP600 - Page 259

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
245
Table 4.4.7.7-1 Prefix dialing Table Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Numbering
Plan
Select Numbering Plan (0~6).
 Unknown
 ISDN Telephony
 Data numbering
 Telex
 National standard
 Private
 Reserved
Refer to
description
Unknown
Sending
Complete
Select Sending Complete option. (On/Off)
ON/OFF
OFF
Call Charge
Type
Call Charge Type (0~5).
 Unknown
 Local
 long distance
 International
 Mobile
 Reserved
Refer to
description
Unknown
Call Charge
Timer
Call Charge Timer can be assigned. By this time value, Call Metering
can be established.
000-999
0
Call Cost
Call TIMER calculates cost. (ex: timer is 1 min, the cost is 000020,
then after the 3-minute call, total call cost is calculated to 000060)
000000-
999999
000000
Flat Rate
If Flat Rate is ON, Flat Rate is applied by CALL COST per a call.
ON/OFF
OFF
Base Call
Cost
If this value is set, the base cost is applied.
That means the first charge is applied to Base Call Cost, and the
second charge is applied to the Call Cost Per Call Charge Timer.
If Base Call Cost is 0, the base cost is not applied.
000000-
999999
000000