EasyManua.ls Logo

iPECS UCP600 - Page 293

iPECS UCP600
721 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
279
Table 4.4.8.7-1 SIP PHONE ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Do Not
Overwrite
Station Name
This feature can be set in case of the following Range:
OFF(REG): Extension name will be updated with displayed in
REGISTER message.
ON: The extension name will not be updated.
OFF(INV): Extension name will be updated with displayed in
the INVITE message.
OFF(REG+INV): Extension name will be updated with
displayed in REGISTER or INVITE message.
Refer to
description
OFF
(REG)
Follow CO
Enblock
Process
Skip the "dial tone by system" phase and deliver a transparent
message of CO trunk to the SIP phone.
OFF
ON
OFF
Suffix DID
Table to CLI
If this option is ON, CLI is published by suffixing DID Conversion
table index.
OFF
ON
OFF
SIP Profile
Select the SIP Profile type between Default and CISCO-CP.
Default: Normal SIP phone.
CISCO-CP: CISCO SIP phone.
Default,
CISCO-CP
Default
SIP Name
Display
Deliver display name of SIP extension to SIP trunk without
modification.
ON: Deliver display name of SIP extension to SIP trunk without
modification.
OFF: Send name according to system rule (station name/speed
name etc.)
OFF
ON
OFF
CO Access
Code
When the ELG SIP phone receives an incoming trunk call, the Call-
Info header is inserted. - “Call-Info: co-access XX.
XX value is used for a callback from the SIP phone log.
OFF: Call-Info is not inserted.
1st Co Code: PGM106- Access CO in First CO Group will be
used as XX.
CO Grp Code: Co Group Code+Co Group number will be
used as XX.
CO Number: Individual CO Access Code + Co Number will be
used as XX.
Refer to
description
1st Co
Code.
ALTC Usage
ALTC Usage of SIP phone in case of IPV6 connection.
OFF: ALTC is not used.
ON: ALTC is used.
OFF
ON
OFF
INVITE(Replac
e) Usage
Original Caller ID is shown in ringing for blind transfer in the below
case.
If INVITE(Replace) Usage is on and Replace header in the
INVITE message is supported on the SIP phone
OFF
ON
OFF

Table of Contents

Related product manuals