iPECS UCP600 - Page 328

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
314
Table 4.4.9.17-1 MOBILE EXTENSION TABLE
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Notify CLI
When the system sends CLI to the Mobile Extension, the CLI can
be either the original caller’s CLI or the CLI of the station.
Caller,
My Ext.
Caller
Call Back
If “ON,” an incoming Mobile Extension call will be released before
answered, and the system places a call to Mobile Extension. After
the Mobile answers, the dial tone is provided, and the Mobile
Extension can place internal or external calls.
OFF
ON
OFF
Delay Timer
When the Mobile Extension requests a Call Back, the system will
place the Call Back after the expiration of this Delay timer.
0 ~ 255
0
Announcement
A system announcement can be recorded to provide the Mobile
caller with a menu of dialing commands available to the mobile
user's remote control.
0-200
0
CO Group
The CO/IP Line group used to call (ring) the Mobile Extension is
defined.
eMG80/100:1~20, eMG800:1~200, UCP: 1~200
Refer to
description
1
Telephone
Number
The telephone number of the Mobile extension or Fail-over
number of the station must be assigned for proper operation.
Not
assigned
CLI Number
When the Mobile Telephone number and CLI do not match, the
CLI entered here is used to authorize incoming calls from the
Mobile.
Not
assigned
Suffix DID table
index to the CLI
An incoming DID call is passed to the Mobile Extension with the
original caller’s CLI, and the Flexible DID Conversion Table index.
(format: ‘original CLI’ + ‘*’ + ‘DID Table Index’)
OFF/ON
OFF
Tel Num As
CLI Num
If this option is set to ON, the Telephone Number is used the
same as CLI Number.
That means, when the mobile user calls to his station, if
Telephone Number or CLI Number is matched with his mobile
number, then the mobile user hears system dial tone, and calling
to the outside is available.
If this option is set to OFF, only CLI Number is matched, system
dial tone is served.
OFF/ON
ON