iPECS UCP600 - Page 361

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
347
Table 4.4.13.3-1 DEVICE ZONE ATTRIBUTES
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Codec Type
The codec selection method can be defined as device-based,
see PGM 132, or based on the codec type assigned to the Zone.
Follow Zone, Follow Me (ADM132)
Refer to
description
Follow Me
(ADM132)
RTP Relay
Group
This attribute defines the RTP Relay group employed by the
device, 00-no relay. Zone parameters define the VoIP device to
employ.
00-15
00
(no relay)
Page Area
Group
The Paging Area Group identity is employed to determine when
multicast to unicast conversion is needed to relay paging data
across the network using a VoIP channel of a VOIU/VOIM or
Paging Agent (VoIP channel of an iPECS LIP Phone).
00: same paging relay area
00-15
00
VM Device Slot
Sequence.
(VMIU/VMIB Slot
Sequence)
The VSF gateway used to support Voice Mail for a device is
defined. The VSF/UVM must be under the control of the same
eMG/UCP as the device.
eMG80/100: Max. 3 Digits, eMG800/UCP: Max. 4Digits
Refer to
description
Select Default
Multi-Language
The recorded language selection prompt is played to the user
when accessing the built-in AA/VM. The system supports up to
six languages.
1 ~ 6
1
VM Retry Count
The user may select an available language. If the language is
unavailable, the user may attempt to enter a valid language type
based on this retry counter. If the user cannot enter a valid
language, the announcement is provided in the default
language.
0-9
3
Remark
Descriptive information to help installer/programmer in
identifying the device Zone, i.e., Branch1.
Max. 21
characters