iPECS UCP600 - Page 511

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
70
Table C-15 VIRTUAL DIP SWITCH
BTN
SUB-MENU
RANGE
REMARK
lights if the trace is ON)
13
SIP MSG Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
14
FULL SIP Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
15
Hotel Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
16
SIP EXT Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
17
DEBUG Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
18
IPATD Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
19
ISDN Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
20
SPI Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
21
DECT Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
22
HTTP XML Trace
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
PGM: 453 - Virtual Dip Switch Access
1
Device Polling
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
2
SMDI Setting
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
3
Multicast LED
ON/OFF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is ON)
4
Auto-Negotiation
MANUAL/AUTO
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is Manual)
5
Full or Half-duplex
FULL/HALF
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is HALF)
6
100 M or 10 M Tx/Rx bps
100/10
Press Flex Button (Toggle: ON/OFF, LED
lights if the trace is 10 M bps)
Table C-16 DECT DATA
BTN
SUB-MENU
RANGE
DEFAULT
REMARK
PGM: 491 - DECT ATTRIBUTES
1
AUTO CALL RLS
ON/OFF
OFF
2
BASE FAULT ALARM
Enable/Disable
Disable
3
CHAIN FAULT ALARM
Enable/Disable
Disable