iPECS UCP600 - Page 582

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
141
Table 3.3.5.2-3 CO/IP ATTRIBUTES III (PGM 143)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
DEFAULT
22
01-02 CALLED NUM PLAN
(0-6) : UNKNOWN (0)
ISDN Called Party Numbering Plan can be
programmable.
 0: Unknown.
 1: ISDN / Telephony.
 2: Data / Numbering.
 3: Telex.
 4: National Standard.
 5: Private.
 6: Reserved.
Unknown
23
01-02 SCREENING (0-3)
USER PROVIDED, NO S (0)
ISDN Screening Indicator can be programmable.
 0: User-Provided, No Service.
 1: User-Provided, Pass.
 2: User-Provided, Fail.
 3: Network Provided.
User-
Provided,
No
Service.
24
ADDED CO LINE ATT3
PRESS FLEX KEY (1-6)
24-1
01-02 CLI TYPE (1-5)
STN CLI 1 (1)
Outgoing CLI can be chosen from CLI 1 to CLI 5. This
program is combined with PGM 114 – Station CLI 1 to
Station CLI 5.
1 (Station
CLI 1)
24-2
01-02 ISDN PLUSE CODE
….
When incoming CLI starts with “+” code, this Plus code
can be translated as this program.
-
24-3
01-02 CP/ALERT INBAND
(1:ON/0:OFF):OFF
Send progress indication with in-band information in call
proceeding and alerting message.
OFF
24-4
01-02 DISCONNECT INBAND
(1:ON/0:OFF):OFF
Send progress indication with in-band information in
disconnect message.
OFF
24-5
01-02 BURSTTN TO CALLER
(1:ON/0:OFF):OFF
Send to burst tone to a caller if it’s set ON.
OFF
24-6
01-02 DISCONN. (INBAND)
IGNORE (0)
When the system receives a DISCONNECT message
with Inband information from PSTN, the following option
can be applied:
 Ignore Inband information: Line is disconnected
 Bypass Inband information: Progress Information
is transferred
 Wait Release: The system wait to send a Release
message till the other party is disconnected
Ignore