iPECS UCP600 - Page 593

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
152
Table 3.3.5.9-1 ISDN CO LINE ATTRIBUTES (PGM 151)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
8
01-02 T305 (10 – 60)
(10-60) : 30 (sec)
T305 establishes the Interval for a Released
signal after receiving a Disconnect message.
10~60
(seconds)
30
9
01-02 T308 (01 – 10)
(01-10) : 04 (sec)
T308 establishes the Interval for a Released
ACK signal after sending a release message.
1~10
(seconds)
4
10
01-02 T309 (001 – 100)
(001-100) : 090 (sec)
Optional state timer.
1~100
(seconds)
90
11
01-02 T310 (10 – 60)
(10-60) : 40 (sec)
Timer used in accepting Received signal.
10~60
(seconds)
40
12
01-02 N200 (1 – 5)
(1-5) : 3
The terminal shall provide one N200 counter
for each logical link supported. The default
value of this counter shall be 3.
1~5
3
13
01-02 N201 (250 – 300 )
(250~300) : 260 (byte)
The N201 counter sets the maximum number
of Octets in the ISDN information field.
250~300
(bytes)
260
14
01-02 N202 (1 – 5)
(1-5) :3
If the terminal transmits a TEI Identify
Request message (to request assignment of
a TEI), the terminal shall provide one N202
counter for each logical link that it supports.
1~5
3
15
01-02 N204 ( 1 – 5)
(1-5) : 1
The N204 counter establishes the maximum
number of XID re-transmissions from the
terminal.
1~5
1
16
01-02 K_VALUE
(1-5) : 1
The terminal shall provide one K counter for
each logical link supported.
1~5
1