iPECS UCP600 - Page 704

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
263
Table 3.3.11.2-1 TNET CM ATTRIBUTES (PGM 331)
BTN
ATTRIBUTE/DISPLAY
DESCRIPTION
RANGE
DEFAULT
2
CM SERVER TYPE
0:LIK / 1:CM : LIK(0)
This field defines Central Call Manager type.
The LIK is eMG/UCP even though the display is
LIK.
0:LIK
1: CM
LIK
3
CM1 IP ADDRESS
0 .0 .0 .0
This field defines the IP address of the CM1 that
the LM will use.
IPv4
address
4
CM2 IP ADDRESS
0 .0 .0 .0
This field defines the IP address of the CM2 that
the LM will use.
IPv4
address
5
CM1 MAC ADDRESS
000000000000
This field defines the MAC address of the CM1
that the LM will use.
6
CM2 MAC ADDRESS
000000000000
This field defines the MAC address of the CM2
that the LM will use.
7
CM IPKTS PORT
(0001 - 9999) :5588
In the TNET environment, the IP KTS protocol
signaling the UDP port is defined. At present,
this field is not used, do not change this port
number.
0000-
9999
5588
8
CM TOTAL PORT
(000 – 999) : 011
This field defines the total number of ports the
LM will request to be allocated by the CM for
devices attached to the LM.
This value must be equal to or less than the port
count in the CM for the LM devices.
000-999
000
9
POLLING COUNT
(00 – 99) : 05
This field defines the maximum polling failures
an LM considers a WAN fault.
00-99
05
10
POLLING INTERVAL
(00 – 99) : 02
This field defines the interval time between LM
to CM polling attempts.
00-99
02