iPECS UCP600 - Page 85

iPECS eMG80/100& eMG800 & UCP & vUCP
Administration and Programming Manual Issue 2.5
71
Table 4.4.2.4-1 CLI Attributes
ATTRIBUTE
DESCRIPTION
RANGE
DEFAULT
Call wait signal
continuous
When this field is set On, you will continuously get the call wait
signal without returning to the current conversation. In the case
of Off, you will return to the current conversation after 1 cycle
of Call waits for signal indication.
ON,
OFF
OFF
Call wait signal
duration (*3sec.) of
a call
You can set the call wait signal duration of a waiting call: the
default is 2 (2*3sec.), and the range is from 0 to 20.
0-20
(*3sec)
2
CLIP Display
CLIP (Calling Line Identification Presentation), a carrier
service, sends the calling party's number to the system in the
call SETUP message. If enabled here, the number will be
shown in the iPECS Phone LCD.
OFF
ON
ON
COLP Display
COLP (Connected Line Id Presentation), a carrier service,
sends the number of the answering party to the system in the
call CONNECT message. If enabled here, the number will be
shown in the iPECS Phone LCD.
OFF
ON
ON
CLIR Service
CLIR (Calling Line Identification Restriction), a carrier service,
removes the calling party ID sent from the ISDN to the called
party with a RESTRICT instruction in the SETUP message. If
enabled here, the system will send the RESTRICT instruction
to the PSTN when an outgoing ISDN call is placed.
OFF
ON
OFF
COLR Service
COLR (Connected Line Id Restriction), a carrier service,
removes connected party ID sent from the ISDN to the calling
party with a RESTRICT instruction in the CONNECT message.
If enabled here, the system will send the restricted instruction
to the PSTN when the station answers an ISDN call.
OFF
ON
OFF
CLI Name Display
When the Incoming CLI data from the carrier matches a
number in Speed Dial, or Outgoing dial data from a user
matches a number in Speed Dial, the system can display the
name associated with the Speed Dial bin is set to ON.
OFF
ON
ON
CLI/IP Message
Wait
A log of missed calls with caller identification can be
maintained, permitting the user to call back the identified party.
Up to 1000 entries are maintained in the log system-wide.
OFF
ON
OFF
FASTCLI For
Transfer Call
If this option is set to ON, when a transferred call is routed to
an SLT or DECT phone, and the CLI for the CO/IP call is sent
to the SLT or DECT phone instead of transferring the station
number.
OFF
ON
OFF
E.164 Call Log CLI
(for SIP Extension)
WHEN ENABLED, the E.164 format CLI is sent to SIP
Extensions for an incoming CO/IP call.
OFF
ON
OFF