Lexmark X95 series - Page 55

Diagnostic information 2-5
7558-xxx
Go Back
Previous
Next
Fax Station Number not
set up
The Fax Station Number has not been entered. Sending and receiving faxes is
disabled until fax is configured properly.
Try one or more of the following:
• Touch Continue to clear the message.
• Complete the Analog Fax Setup. If the message appears again, contact your
system support person.
Insert Tray [x] Insert the specified tray into the printer.
Insert the hole punch
box
Insert the hole punch box into the finisher, and then touch Continue to clear the
message.
Install Tray [x] Try one or more of the following:
• Install the specified tray:
1. Turn the printer off.
2. Unplug the power cord from the wall outlet.
3. Install the specified tray.
4. Connect the power cord to a properly grounded electrical outlet.
5. Turn the printer back on.
• Cancel the print job.
Load [src] with [custom
type name]
Try one or more of the following:
• Load the specified paper in the tray or feeder.
• Touch Paper loaded, continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, it feeds from
that tray. If the printer cannot find a tray with the correct paper type and size, it
prints from the default paper source.
• Cancel the print job.
Load [src] with [custom
string]
Try one or more of the following:
• Load the specified paper in the tray or feeder.
• Touch Paper loaded, continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, it feeds from
that tray. If the printer cannot find a tray with the correct paper type and size, it
prints from the default paper source.
• Cancel the print job.
Load [src] with [size] Try one or more of the following:
• Load the specified paper in the tray or feeder.
• Touch Paper loaded, continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, it feeds from
that tray. If the printer cannot find a tray with the correct paper type and size, it
feeds from the default paper source.
• Cancel the print job.
Load [src] with [type]
[size]
Try one or more of the following:
• Load the specified paper in the tray or feeder.
• Touch Paper loaded, continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, it feeds from
that tray. If the printer cannot find a tray with the correct paper type and size, it
feeds from the default paper source.
• Cancel the print job.
Load Manual Feeder
with [custom type name]
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Prompt each page, paper loaded to clear the message and continue
printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray. If the printer cannot find a tray with the correct paper type and
size, then it prints from the default paper source.
• Cancel the print job.
User status and attendance messages
User primary message Explanation