2-6 Service Manual
7558-xxx
Load Manual Feeder
with [custom string]
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Prompt each page, paper loaded to clear the message and continue
printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray If the printer cannot find a tray with the correct paper type and
size, then it prints from the default paper source.
• Cancel the print job.
Load Manual Feeder
with [size]
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Prompt each page, paper loaded to clear the message and continue
printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray. If the printer cannot find a tray with the correct paper type and
size, then it prints from the default paper source.
• Cancel the print job.
Load Manual Feeder
with [type] [size]
Try one or more of the following:
• Load the specified paper in the multipurpose feeder.
• Touch Prompt each page, paper loaded to clear the message and continue
printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray. If the printer cannot find a tray with the correct paper type and
size, then it prints from the default paper source.
• Cancel the print job.
Load staples Try one or more of the following:
• Replace the specified staple cartridge in the finisher.
• Touch Continue to clear the message and continue printing.
• Touch Cancel job to cancel the print job.
Manual feeder expects
[paper size]. Check
[paper source] guides
Try one or more of the following:
• Load the specified paper size in the manual feeder.
• Physically adjust [paper source] guides to a recognized paper size.
• Touch Continue to clear the message and continue printing.
If the printer finds a tray that has the correct paper type and size, then it feeds
from that tray. If the printer cannot find a tray with the correct paper type and
size, then it prints from the default source.
Memory full, cannot
print faxes
There is not enough memory to print the fax job.
Touch Continue to clear the message without printing. Held faxes will attempt to
print after the printer has been restarted.
Power off, wait 2
seconds, power on
Turn the printer off and wait for 2 seconds before turning the printer back on.
Remove paper from
standard output bin
Remove the stack of paper from the standard exit bin.
Remove paper from bin
[x]
Remove the paper from the specified bin. The printer automatically senses paper
removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from
[linked bin set name]
Remove the paper from the specified bin. The printer automatically senses paper
removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
Remove paper from all
bins
Remove the paper from all of the bins. The printer automatically senses paper
removal and resumes printing.
If removing the paper does not clear the message, then touch Continue.
User status and attendance messages
User primary message Explanation
To Next Page
Loading...
