xii
5.5.4 Installing Option 550 Paper Feeder
For details, refer to the Instruction Manual supplied with the main unit or Chapter 3 RRP
20.1 Option 550 Paper Feeder.
Before the installation, turn off the power, plug off the power cord, and remove the
paper tray from the laser printer.
1) Unpack the Option 550 Paper Feeder, remove cushioning materials, and confirm
that all attachments are available.
2) Place the Option 550 Paper Feeder in an installation location.
3) Fit the holes on the bottom of the laser printer with the four positioning bosses of
the Option 550 Paper Feeder, and place the laser printer on the Option 550 Paper
Feeder.
4) Fix the laser printer and the Option 550 Paper Feeder securely with the JOINT
FEEDERs (four pieces).
5) Push the paper tray into the laser printer completely to install.
6) Connect the power cord.
7) Turn on the power switch of the laser printer.
8) Try some test printings with the newly installed paper-feed tray to confirm that there
is no problem.
To Next Page
Loading...
