Oki B6500

8 - 8
Chapter 8 Printer Specifications
4. Specification
4.1 Base Print Engine Specification
4.1.1 Printing System
Electro-photographic system (roller charging, single component magnetic toner development).
4.1.2 Exposure System
Semiconductor laser beam scanning system.
4.1.3 Transfer System
Roller transfer system.
4.1.4 Fixing System
Thermal fusing system by a heated roller.
4.1.5 Resolution
600 dpi or 1200 dpi (Dual laser beam, 600 dpi/1200 dpi switch-able at full engine speed).
4.1.6 Warm-up Time
The Print Engine shall reach a READY state within 17 sec maximum after the application of power as a
nominal voltage (120V/220V).
: measured at 22
o
C.
4.1.7 First Print Output Time (FPOT)
The First Print Output Time (FPOT) shall be defined as the time from when the printer receives a START
signal in the READY state, until a single page is printed and delivered into the output tray, under the
scanning condition (Fuser Ready).
The following data are theoretical values without misfeed margin (0.2 sec.).
:
1. SEF: Short Edge Feed
2. Duplex: 1 sht.Batch Mode
3. FPOT from sleep mode
Configuration
Paper
Size
Mode
Tray 1
(t sec)
Tray 2
(t sec)
Tray 3
(t sec)
Tray 4
(t sec)
Tray 2 Exit
550 500
Letter
SEF
Simplex 7.9 7.9 7.9 8.2
Duplex 11.1 11.1 11.1 11.3
A4 SEF
Simplex 7.9 7.9 7.9 8.2
Duplex 11.2 11.2 11.2 11.4
Configuration
Paper
Size
Mode
Tray 1
(t sec)
Tray 2
(t sec)
Tray 3
(t sec)
Tray 4
(t sec)
Tray 2 Exit
550 500
Letter
SEF
Simplex 24.9 24.9 24.9 25.2
Duplex 28.1 28.1 28.1 28.3
A4 SEF
Simplex 24.9 24.9 24.9 25.2
Duplex 28.2 28.2 28.2 28.4