Rohde & Schwarz R&S SMW200A - Page 168

Signal Routing and System Configuration
R&S
®
SMW200A
168User Manual 1175.6632.02 ─ 30
Settings:
State............................................................................................................................168
Connector....................................................................................................................168
Interface...................................................................................................................... 168
Sample Rate Source...................................................................................................168
Connected Device.......................................................................................................169
State
Enables the feeding of the selected external digital signals into the baseband.
Remote command:
[:SOURce<hw>]:BBIN:STATe on page 956
Connector
Defines the connector used as an external signal source.
Available are all digital input connectors, as defined with "System Configuration >
External RF and I/Q > Direction > Input" (see Direction).
"FADER 1 IN/FADER 2 IN"
Option: R&S SMW-B14
Remote command:
[:SOURce<hw>]:BBIN:DIGital:SOURce on page 957
Interface
Option: R&S SMW-B9
Sets which of the digital interfaces is used, the DIG I/Q or the HS DIG I/Q.
Remote command:
[:SOURce<hw>]:BBIN:DIGital:INTerface on page 957
Sample Rate Source
Selects whether the sample rate is estimated based on the digital input signal or is a
manually entered value.
(See also Chapter 4.3.5, "Important Signal Parameters and Interface's Characteristics",
on page 119).
Digital Baseband Input Settings