Configuring the Internal Baseband Source
R&S
®
SMW200A
302User Manual 1175.6632.02 ─ 30
If the current instrument configuration uses Coupled sources, you can assign
waveforms to all available basebands.
The dialog is divided into several tabs. In each case, the current setting is dis-
played in the tab name.
The remote commands required to define these settings are described in Chap-
ter 14.19.4.3, "SOURce:BB:ARBitrary Subsystem", on page 1019.
Settings:
● ARB General Settings...........................................................................................302
● Sine Test Signals...................................................................................................307
● Rectangular Test Signal........................................................................................ 308
● Constant IQ Test Signal........................................................................................ 310
● Trigger, Marker and Clock Setting.........................................................................311
5.7.3.1 ARB General Settings
Access:
► Select "Baseband > ARB".
This tab provides access to the default ARB settings, selecting a waveform file and
enabling the ARB generator.
Further settings depend on selected "System Configuration" and waveform type:
●
If a single segment waveform is used, the tab provides also settings for configuring
the test signal and access to the settings for calculating a multi-segment or a multi-
carrier waveform.
●
If a multi-segment waveform is loaded, the tab expands and displays the dedicated
section "Multi Segment Waveform Options".
Using the Arbitrary Waveform Generator (ARB)
To Next Page
Loading...