Getting Started
R&S
®
SMW200A
47User Manual 1175.6632.02 ─ 30
1
9101112
BBMM
2 3 4 5 6 7 8 9
13141516
Figure 3-8: Instrument boards: R&S
SMW-B9/-B13XT/-B15 (wideband baseband)
1, 6, 13, 15 = DIG I/Q, page 50
2, 7, 12, 14 = HS DIG I/Q, page 51
3, 8 = ADV DATA/CTRL, page 51
4, 9 = T/M/C, page 49
5, 16 = Board designation (CODER, FADER, BBMM)
9 = I/Q, I/Q Bar, page 51
10 = EXT x 1/2, page 50
11 = ADV TRIG, ADV CLK, page 51
3.2.2.1 Connectors
I/Q
Rear panel I/Q input connectors, recommended for use of the instrument in a 19" rack.
See "I/Q, I/Q Bar" on page 42.
How to:
●
Chapter 3.1.4.2, "Mounting the R&S SMW in a Rack", on page 29
●
"To apply an external analog signal directly to the I/Q modulator" on page 213
●
"To apply an external differential analog signal directly to the I/Q modulator"
on page 213
RF A/RF B
Rear panel RF output connectors for the first RF path (option R&S SMW-B81/-B83)
and the second RF path (option R&S SMW-B82/-B84). These options are recommen-
ded for use of the instrument in a 19" rack.
How to:
●
Chapter 3.1.4.2, "Mounting the R&S SMW in a Rack", on page 29
●
Chapter 3.1.9, "Connecting to RF A/RF B", on page 33
REF IN/REF OUT
Input/output for external reference signal.
BNC connectors for reference signals from 1 MHz to 100 MHz.
Instrument Tour
To Next Page
Loading...