Multi-Instrument Setups
R&S
®
SMW200A
658User Manual 1175.6632.02 ─ 30
:SCONfiguration:RFALignment:SETup:INFO:CALibration:POWer:RANGe:
LOWer? on page 942
:SCONfiguration:RFALignment:SETup:INFO:CALibration:POWer:RANGe:
UPPer? on page 942
Frequency Step/PEP Step ← Frequency/PEP Control
This value is displayed if "Mode = Range" is used during the calibration. It indicates the
frequency/PEP step size that is used to define the frequency and level values to be
calibrated with the range, defined with the min and max values.
Remote command:
:SCONfiguration:RFALignment:SETup:INFO:CALibration:FREQuency:
STEP? on page 942
:SCONfiguration:RFALignment:SETup:INFO:CALibration:POWer:STEP?
on page 942
Frequency Values/PEP Values ← Frequency/PEP Control
This value is displayed if "Mode = List" is used during the calibration.
It indicates the calibrated values, that are defined as a sequence of comma-separated
discrete values in the required units.
Remote command:
:SCONfiguration:RFALignment:SETup:INFO:CALibration:FREQuency:
LIST:VALues? on page 941
:SCONfiguration:RFALignment:SETup:INFO:CALibration:POWer:LIST:
VALues? on page 941
LO Coupling ← Frequency/PEP Control
Indicates whether the instruments use a common local oscillator (LO) signal or not.
"Active"
All instruments are connected to the same LO reference frequency.
"Inactive"
Each instrument uses its own local oscillator.
Remote command:
:SCONfiguration:RFALignment:SETup:INFO:CALibration:LOCoupling?
on page 942
Generating Phase-Coherent Synchronous and Aligned Signals
To Next Page
Loading...