Signal generation (option R&S RTM-B6)
R&S
®
RTM3000
405User Manual 1335.9090.02 ─ 09
Remote command:
WGENerator:OUTPut[:ENABle] on page 781
Function
Selects the type of waveform to be generated. For all waveforms, you can set the Fre-
quency, Amplitude, Offset, and Noise.
"DC"
Generates a direct current (DC) signal.
"Sine"
Generates a sine wave.
"SinC"
Generates a cardinal sine wave.
"Rectangle"
Generates a square wave.
"Pulse"
Generates a pulse signal. Additional settings are the Duty Cycle and
the Edge Time.
"Triangle"
Generates a triangle signal.
"Ramp"
Generates a ramp signal. You can set the Polarity.
"Arbitrary"
Generates an arbitrary waveform, which is copied from an existing
waveform, or loaded from file. See Chapter 16.1.6, "Arbitrary setup
settings", on page 411.
"Exponential"
Generates an exponential rise signal. You can set the Polarity.
Remote command:
WGENerator:FUNCtion on page 779
Frequency
Sets the frequency of the waveform. The available frequency range depends on the
selected function. The frequency ranges are provided the datasheet.
Remote command:
WGENerator:FREQuency on page 780
Amplitude
Sets the amplitude of the waveform.
Remote command:
WGENerator:VOLTage on page 779
Offset
Sets the vertical offset of the generated waveform.
Remote command:
WGENerator:VOLTage:OFFSet on page 780
Noise
Sets the noise of the generated waveform.
Remote command:
WGENerator:NOISe:ABSolute on page 781
WGENerator:NOISe:RELative on page 781
Polarity
Sets the polarity for ramp and exponential functions.
Function generator
To Next Page
Loading...
Need help?
General
