Waveform setup
R&S
®
RTM3000
68User Manual 1335.9090.02 ─ 09
Remote command:
PROBe<m>:SETup:DEGauss on page 447
Info
Same as for active single-ended probes, see "Info" on page 65.
5.4.3.4 High-voltage differential probes
Rohde & Schwarz high-voltage differential probes of the R&S RT-ZHD series have the
same settings as active broadband differential probes, and additional range settings.
Other high-voltage differential probes have a BNC interface, dor setup, see Chap-
ter 5.4.2, "Probe settings for probes with BNC connector", on page 62.
Access: [Ch <n>] > "Probe" (scroll down); or short menu > "Probe"
Figure 5-5: Probe settings of R&S
RT-ZHD16 with results of ProbeMeter measurement
Copy to offset
Same as "Copy to offset" for active broadband single-ended probes, see "Copy to off-
set" on page 64. The offset value is also shown in the "Channel <n>" menu.
ProbeMeter
®
Same as "ProbeMeter
®
" for active broadband single-ended probes, see "ProbeMeter
®
"
on page 64.
MicroButton
Same as for active single-ended probes, see "MicroButton" on page 64.
Input voltage range
Sets the voltage range of a R&S RT-ZHD probe. You can set the range on the probe
control box or at the oscilloscope.
Probes
To Next Page
Loading...
