Remote control commands
R&S
®
RTP
1211User Manual 1337.9952.02 ─ 12
TRPRobe:SETup:DISPlaydiff <DisplayDiff>
PROBe<m>:SETup:DISPlaydiff <DisplayDiff>
Selects the input voltages to be measured by the ProbeMeter of an R&S differential
active probe.
See also: "Differential active probes" on page 140.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<DisplayDiff> DIFFerential | SINGleended
DIFFerential
Measures differential and common mode voltages
SINGleended
Measures the voltage between the positive/negative signal
socket and the ground.
*RST: DIFFerential
Usage: Asynchronous command
TRPRobe:PMETer:VISibility <Visibility>
PROBe<m>:PMETer:VISibility <Visibility>
Activates the integrated R&S ProbeMeter of active R&S probes.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<Visibility> ON | OFF
*RST: OFF
Usage: Asynchronous command
Firmware/software: FW 2.25
TRPRobe:PMETer:RESults:SINGle?
PROBe<m>:PMETer:RESults:SINGle?
Returns the ProbeMeter measurement result of single-ended active R&S probes, the
voltage measured between the probe tip and the ground.
Suffix:
<m>
.
1..4
Selects the input channel.
Acquisition and setup
To Next Page
Loading...
