Rohde & Schwarz RTP044 - Page 1215

Remote control commands
R&S
®
RTP
1215User Manual 1337.9952.02 ─ 12
TRPRobe:SETup:GAIN:MANual <GainManual>
PROBe<m>:SETup:GAIN:MANual <GainManual>
Sets the gain of a current probe.
Suffix:
<m>
.
1..4
Selects the input channel. The number of channels depends on
the instrument.
Parameters:
<GainManual> Range: 100E-6 to 10000
Increment: 100E-6
*RST: 1
Default unit: V/A
Usage: Asynchronous command
22.8.7.4 Active voltage probes
TRPRobe:SETup:CMOFfset..........................................................................................1215
PROBe<m>:SETup:CMOFfset...................................................................................... 1215
TRPRobe:SETup:ZAXV................................................................................................1216
PROBe<m>:SETup:ZAXV.............................................................................................1216
TRPRobe:SETup:ACCoupling....................................................................................... 1216
PROBe<m>:SETup:ACCoupling....................................................................................1216
PROBe<m>:SETup:ADVanced:PMToffset.......................................................................1216
PROBe<m>:SETup:ADVanced:RANGe..........................................................................1216
TRPRobe:SETup:ADVanced:FILTer............................................................................... 1217
PROBe<m>:SETup:ADVanced:FILTer............................................................................ 1217
TRPRobe:SETup:ADVanced:AUDioverload.................................................................... 1217
PROBe<m>:SETup:ADVanced:AUDioverload................................................................. 1217
TRPRobe:SETup:CMOFfset <CMOffset>
PROBe<m>:SETup:CMOFfset <CMOffset>
Sets the common-mode offset. The setting is only available for differential probes.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<CMOffset> Range: -100E+24 to 100E+24
Increment: 1E-3
*RST: 0
Default unit: V
Usage: Asynchronous command
Acquisition and setup