Remote control commands
R&S
®
RTP
1853User Manual 1337.9952.02 ─ 12
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:DPHY:ESDTa:
MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:DPHY:ESDTa:MIN and
TRIGger<m>:DPHY:ESDTa:MAX.
OFF | ANY
Any pattern is detected.
*RST:
EQUal
TRIGger<m>:DPHY:ESDTa:MAX
<LPEscapeDataMax>
Sets the the end value of a escape mode data type range if TRIGger<m>:DPHY:
ESDTa:CONDition is set to INRange or OORange.
Parameters:
<LPEscapeDataMax>
TRIGger<m>:DPHY:ESDTa:MIN <LPEscapeDataMin>
Specifies an escape mode data bit pattern, or sets the the start value of a pattern
range.
Parameters:
<LPEscpMdDatMin>
TRIGger<m>:DPHY:ESINdex:CONDition <Format>
Sets the condition for the escape mode data index. You can define an exact value or a
value range.
Parameters:
<Format> EQUal | LTHan | LETHan | GTHan | GETHan | INRange |
RANGe
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with the corresponding TRIGger<m>:DPHY:ESINdex:
MIN command.
INRange = RANGe
In range: Set the minimum and maximum value using
TRIGger<m>:DPHY:ESINdex:MIN and TRIGger<m>:DPHY:
ESINdex:MAX.
*RST:
INRange
Protocols
To Next Page
Loading...
