Remote control commands
R&S
®
RTP
1854User Manual 1337.9952.02 ─ 12
TRIGger<m>:DPHY:ESINdex:MAX <DXSymbol>
Sets the the end value of a data index range if TRIGger<m>:DPHY:ESINdex:
CONDition is set to INRange or RANge.
Parameters:
<DXSymbol> Range: 0 to 255
Increment: 1
*RST: 0
TRIGger<m>:DPHY:ESINdex:MIN
<SymbolType>
Specifies an escape mode data index minimum, or sets the the start value of a range.
Parameters:
<SymbolType> Range: 0 to 255
Increment: 1
*RST: 0
TRIGger<m>:DPHY:HSVC <HSVC>
Sets the virtual channel to be triggered on.
Parameters:
<HSVC>
TRIGger<m>:DPHY:WCOunt:CONDition <Format>
Set the condition for the word count. You can define an exact value or a value range.
Parameters:
<Format> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with the corresponding TRIGger<m>:DPHY:WCOunt:
MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:DPHY:WCOunt:MIN and
TRIGger<m>:DPHY:WCOunt:MAX.
*RST:
EQUal
TRIGger<m>:DPHY:WCOunt:MAX <HSWordCountMax>
Sets the the end value of a data type range if TRIGger<m>:DPHY:WCOunt:
CONDition is set to INRange or OORange.
Protocols
To Next Page
Loading...
