Rohde & Schwarz RTP044 - Page 2071

Remote control commands
R&S
®
RTP
2071User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
<n> *
Selects the frame number.
<o> *
Selects the field number.
Return values:
<FieldValue>
Usage: Query only
BUS<m>:USBThree:RESult:FRAMe<n>:FLD<o>:FVAL?
Returns the formatted value of the field with the selected field number within the frame
with the selected frame number (for the selected serial bus).
Suffix:
<m>
.
1..4
<n> *
Selects the frame number.
<o> *
Selects the field number.
Return values:
<ValueFormatted>
Usage: Query only
22.17.20.5 Search settings
There are two commands for each parameter, that you can use for defining the SSIC
search settings.
For example, to set the Frame type =ACK > Field =Route String >Data value you can
use one of the following commands:
●
SEARch:TRIGger:USBThree:FRAMe13:FLD1:DMIN 01100
Defines the parameter by using the index <m> for the frame number and <n> for
the field number. For an overview, see Table 22-13.
●
SEARch:TRIGger:USBThree:DMIN "ACK", "Route String", 01100
Defines the parameter by using the frame and field name.
SEARch:TRIGger:USBThree:ERENable.........................................................................2072
SEARch:TRIGger:USBThree:ERRor<m>:ENABle........................................................... 2072
SEARch:TRIGger:USBThree:FRENable.........................................................................2072
SEARch:TRIGger:USBThree:FRAMe<m>:ENABle.......................................................... 2072
SEARch:TRIGger:USBThree:FIENable.......................................................................... 2073
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:ENABle............................................. 2073
SEARch:TRIGger:USBThree:DOPerator........................................................................ 2073
SEARch:TRIGger:USBThree:FRAMe<m>:FLD<n>:DOPerator......................................... 2073
Protocols