Rohde & Schwarz RTP044 - Page 2106

Remote control commands
R&S
®
RTP
2106User Manual 1337.9952.02 ─ 12
22.17.22.1 Configuration
BUS<m>:SWIRe:BPOSition.......................................................................................... 2106
BUS<m>:SWIRe:DATA:HYSTeresis...............................................................................2106
BUS<m>:SWIRe:DATA:SOURce................................................................................... 2106
BUS<m>:SWIRe:DATA:THReshold................................................................................2107
BUS<m>:SWIRe:MGAP................................................................................................2107
BUS<m>:SWIRe:STRBe:HYSTeresis.............................................................................2107
BUS<m>:SWIRe:STRBe:SOURce.................................................................................2107
BUS<m>:SWIRe:STRBe:THReshold..............................................................................2108
BUS<m>:SWIRe:SYSLect............................................................................................ 2108
BUS<m>:SWIRe:COUPling...........................................................................................2108
BUS<m>:SWIRe:PRESet..............................................................................................2108
BUS<m>:SWIRe:BPOSition <SyncBitPos>
Sets the bit position, the align position for the manual synchronisation mode. This can
be useful when parity errors exist in the signal, and parity check is the main indicator
for the decoder to do packet alignment.
Suffix:
<m>
.
1..4
Parameters:
<SyncBitPos> Range: 0 to 10
Increment: 1
*RST: 0
BUS<m>:SWIRe:DATA:HYSTeresis <HysteresisData>
Sets a value for the hysteresis of the data signal.
Suffix:
<m>
.
1..4
Parameters:
<HysteresisData> Range: 0 to 0.8
Increment: 0.01
*RST: 0.2
Default unit: V
BUS<m>:SWIRe:DATA:SOURce <SourceData>
Selects the source of the data signal.
Suffix:
<m>
.
1..4
Protocols