Rohde & Schwarz RTP044 - Page 2283

Remote control commands
R&S
®
RTP
2283User Manual 1337.9952.02 ─ 12
●
n= 4...16: sets only one offset value that is relevant for all advanced jitter com-
ponents.
●
n= 17...29: sets only one offset value that is relevant for all advanced noise
components.
Suffix:
<m>
.
1..2
<n> 1..29
See Table 22-20
Parameters:
<Offset> Range: -1E+15 to 1E+15
Increment: 1E-6
*RST: 0
Default unit: s
ADVJitter<m>:DCOMposition:SPJTable
<State>
Enables the display of the periodic jitter components table.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: ON
ADVJitter<m>:DCOMposition:SPJLabels <State>
Enables the display of the periodic jitter components labels.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:DCOMposition:SPNLabels <State>
Enables the display of the periodic noise components labels.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
Jitter analysis and clock data recovery