Mask testing
R&S
®
RTP
427User Manual 1337.9952.02 ─ 12
Make sure that the correct "Mask Test" tab is selected on the left side before you enter
the settings.
Remote commands:
MTESt:ADD on page 1459
MTESt:REMove on page 1460
Enable
Activates and deactivates the mask test. If the acquisition is running, the test starts
immediately. Otherwise, the test starts when acquisition is started.
The testing is stopped when acquisition is stopped, or if a stop action is configured with
"Stop acq." on page 436.
Closing the result box also disables the mask test.
Remote command:
MTESt[:STATe] on page 1460
Target
Selects the waveform to be tested against the mask. All channel waveforms can be
tested.
Remote command:
MTESt:SOURce on page 1460
Mask Type
Sets the method of mask definition.
"User"
The mask is created manually by tapping the mask points on the
touch screen and/or by entering the numerical x- and y-values of the
mask points.
"Waveform"
The mask is created from an existing waveform. The waveform builds
the upper and lower limit line of the mask, and the limits are moved
and stretched. The result is a tolerance tube around the waveform
that is used as mask.
"Eye"
Requires jitter option R&S RTP-K12.
The mask is created by selecting the shape and setting its dimen-
sions according to the test standard.
Remote command:
MTESt:CTYPe on page 1462
Setup mask
Opens a dialog for defining the mask. See Chapter 10.2.2, "Mask definition",
on page 428.
Save / load mask
Provides all functions to store and recall a mask test. The mask definition, defined
actions and fail conditions are stored in an R&S RTP-specific .xml file.
Mask test settings
To Next Page
Loading...
