Rohde & Schwarz RTP044 - Page 452

Search functions
R&S
®
RTP
452User Manual 1337.9952.02 ─ 12
For serial protocol options, search on a serial bus is available. These searches have
protocol-specific search criteria. For details, see the relevant chapters of the "Protocol
Analysis" chapter.
● Edge......................................................................................................................452
● Glitch.....................................................................................................................453
● Width.....................................................................................................................453
● Runt.......................................................................................................................454
● Window................................................................................................................. 455
● Timeout................................................................................................................. 456
● Interval.................................................................................................................. 457
● Slew rate............................................................................................................... 458
● Setup & Hold.........................................................................................................459
● State......................................................................................................................461
● Pattern...................................................................................................................461
11.2.2.1 Edge
The edge search works the same way as the edge trigger.
Slope
Sets the edge type: rising edge ("Positive"), falling edge ("Negative"), or both.
Remote command:
SEARch:TRIGger:EDGE:SLOPe on page 1485
Level
Sets the voltage level for trigger search. The value is used for all search event types
that require one trigger level. The search trigger level is search-specific, you can define
different levels in different searches for the same event.
Remote command:
SEARch:TRIGger:LEVel[:VALue] on page 1484
Search setup