Rohde & Schwarz RTP044 - Page 659

Protocol analysis
R&S
®
RTP
659User Manual 1337.9952.02 ─ 12
SFD Error ← Errors
Searches for a frame with invalid Start Frame Delimiter (SFD).
Remote command:
SEARch:TRIGger:HBTO:ERRor:SFD on page 1775
13.10.5.2 100BASE-T1 search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:HBTO:FCOunt? on page 1775
●
SEARch:RESult:HBTO:FRAMe<m>:TYPE? on page 1775
●
SEARch:RESult:HBTO:FRAMe<m>:STATe? on page 1776
●
SEARch:RESult:HBTO:FRAMe<m>:STARt? on page 1776
●
SEARch:RESult:HBTO:FRAMe<m>:STOP? on page 1777
●
SEARch:RESult:HBTO:FRAMe<m>:DESTaddress? on page 1777
●
SEARch:RESult:HBTO:FRAMe<m>:SRCaddress? on page 1777
●
SEARch:RESult:HBTO:FRAMe<m>:DATA? on page 1778
●
SEARch:RESult:HBTO:FRAMe<m>:CRC? on page 1778
●
SEARch:RESult:HBTO:FRAMe<m>:NUMWords? on page 1778
●
SEARch:RESult:HBTO:FRAMe<m>:FTYPe? on page 1778
●
SEARch:RESult:HBTO:FRAMe<m>:DSYMbol? on page 1779
●
SEARch:RESult:HBTO:FRAMe<m>:SSYMbol? on page 1779
●
SEARch:RESult:HBTO:FRAMe<m>:WORD<n>:TYPE? on page 1780
●
SEARch:RESult:HBTO:FRAMe<m>:WORD<n>:VALue? on page 1780
13.10.5.3 Searching 100BASE-T1 data
Prerequisite: A serial bus is configured for the 100BASE-T1 signal to be decoded and
analyzed.
The search for events is set up in the following way:
1. Press the [Protocol] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
Ethernet 100BASE-T1 (option R&S
RTP-57)