Protocol analysis
R&S
®
RTP
683User Manual 1337.9952.02 ─ 12
Autoset
Starts software algorithms for determining the signal threshold levels and bitrate.
Remote command:
BUS<m>:FAUToset on page 1549
Glitch filter
Enables the glitch filter on the SCLK and SDATA lines to improve decode accuracy.
The "Glitch filter width" field sets the maximum glitch width to be ignored.
Remote command:
BUS<m>:RFFE:GFILter on page 1815
BUS<m>:RFFE:GFWidth on page 1815
Timing
The gap defines the idle time between the Bus Park Cycle (BP) and Sequence Start
Condition (SSC).
You can define a "Min gap time". The standard defines a minimum of 10 ns to separate
two subsequent command sequences.
Remote command:
BUS<m>:RFFE:MINGap:SELect on page 1815
BUS<m>:RFFE:MINGap:TIME on page 1815
13.12.2.3 Configuring RFFE signals
For details on configuration settings, see Chapter 13.12.2.1, "RFFE configuration set-
tings", on page 680.
1. Press the [Protocol] key on the front panel.
2. Select the tab of the bus you want to set up, for example "SB1".
3. In the "Setup" tab, select the protocol: "RFFE".
4. Select the RFFE "Version".
5. Select the "Read mode".
RFFE (option R&S
RTP-K40)
To Next Page
Loading...
