Rohde & Schwarz RTP044 - Page 1815

Remote control commands
R&S
®
RTP
1815User Manual 1337.9952.02 ─ 12
BUS<m>:RFFE:GFILter <GlitchFilter>
Enables the glitch filter on the SCLK and SDATA lines to improve decode accuracy.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<GlitchFilter> ON | OFF
*RST: OFF
BUS<m>:RFFE:GFWidth
<GlitchFilterWdt>
Sets the maximum glitch width to be ignored.
Suffix:
<m>
.
1..4
Parameters:
<GlitchFilterWdt> Range: 10E-12 to 10E-9
Increment: 10E-12
*RST: 1E-9
Default unit: s
BUS<m>:RFFE:MINGap:SELect <MinGapSelect>
If the minimum gap is enabled, the instrument detects the specified gap.
Set the minimum gap time using BUS<m>:RFFE:MINGap:TIME.
Suffix:
<m>
.
1..4
Parameters:
<MinGapSelect> ON | OFF
*RST: OFF
BUS<m>:RFFE:MINGap:TIME <MinGapTime>
Sets the minimum idle time between the Bus Park Cycle (BP) and Sequence Start
Condition (SSC).
The setting is only relevant if BUS<m>:RFFE:MINGap:SELect is enabled.
Suffix:
<m>
.
1..4
Parameters:
<MinGapTime> Range: 1E-9 to 10E-6
Increment: 1E-9
*RST: 10E-9
Default unit: s
Protocols