Rohde & Schwarz RTP044 - Page 1816

Remote control commands
R&S
®
RTP
1816User Manual 1337.9952.02 ─ 12
BUS<m>:RFFE:RDMD <ReadMode>
Selects, if the standard or synchronous read (SREAD) mode is used.
Suffix:
<m>
.
1..4
Parameters:
<ReadMode> STRD | SREAD
*RST: STRD
BUS<m>:RFFE:VERSion <Version>
Selects the RFFE version.
Suffix:
<m>
.
1..4
Parameters:
<Version> V1DX | V2D0 | V2D1 | V3D0
V1DX: 1.x
V2D0: 2.0
V2D1: 2.1
*RST: V1DX
22.17.13.2 Trigger
The trigger suffix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
For programming examples, see "Triggering on RFFE bus" on page 1140.
TRIGger<m>:RFFE:TYPE.............................................................................................1817
TRIGger<m>:RFFE:ADDRess:CONDition...................................................................... 1819
TRIGger<m>:RFFE:ADDRess:MIN................................................................................1819
TRIGger<m>:RFFE:ADDRess:MAX...............................................................................1820
TRIGger<m>:RFFE:BCOunt:CONDition......................................................................... 1820
TRIGger<m>:RFFE:BCOunt:MIN...................................................................................1820
TRIGger<m>:RFFE:BCOunt:MAX..................................................................................1820
TRIGger<m>:RFFE:DATA:DCON.................................................................................. 1821
TRIGger<m>:RFFE:DATA:DMIN....................................................................................1821
TRIGger<m>:RFFE:DATA:DMAX...................................................................................1821
TRIGger<m>:RFFE:DATA:ICONdition............................................................................ 1822
TRIGger<m>:RFFE:DATA:IMIN..................................................................................... 1822
TRIGger<m>:RFFE:DATA:IMAX.................................................................................... 1822
Protocols