Protocol analysis
R&S
®
RTP
686User Manual 1337.9952.02 ─ 12
Register Read ← Type
Triggers on "Register Read" command sequences. This sequence sends the register
address in the command payload, and reads back one data frame.
You can refine the trigger condition using the same settings as for the "Register Write"
command sequence, see "Register Write" on page 685.
Extended Register Write ← Type
Triggers on "Extended Register Write" command sequences. This sequence sends the
byte count of data frames in the command payload, followed by one address frame
with the address of the first extended register, and up to 16 data frames.
You can refine the trigger condition:
●
Set a slave address condition to trigger only on command sequences that are sent
to the specified slaves.
See: "Slave Addr. /MID " on page 689
●
Set a byte count condition to trigger only on command sequences that send the
specified number of data frames.
See: "Byte count" on page 690
●
Set a register address condition to trigger only on command sequences that write
data to the specified register.
See: "Address" on page 689
●
Set a data pattern condition to trigger on data patterns expected in the message.
See: "Data" on page 690 and "Index" on page 690
Extended Register Read ← Type
Triggers on "Extended Register Read" command sequences. This sequence sends the
byte count of data frames in the command payload, followed by one address frame
with the address of the first extended register, and reads back up to 16 data frames.
You can refine the trigger condition using the same settings as for the "Extended Reg-
ister Write" command sequence, see "Extended Register Write" on page 686.
Extended Register Write Long ← Type
Triggers on "Extended Register Write" command sequences. This sequence sends the
byte count of data frames in the command payload, followed by 2 address frames with
the address of the first extended register, and up to 8 data frames.
You can refine the trigger condition using the same settings as for the "Extended Reg-
ister Write" command sequence, see "Extended Register Write" on page 686.
Extended Register Read Long ← Type
Triggers on "Extended Register Write" command sequences. This sequence sends the
byte count of data frames in the command payload, followed by 2 address frames with
the address of the first extended register, and reads back up to 8 data frames.
You can refine the trigger condition using the same settings as for the "Extended Reg-
ister Write" command sequence, see "Extended Register Write" on page 686.
Interrupt Summary and Notification ← Type
Available only for "Version"= "2.0"/"2.1".
Triggers on "Interrupt Summary and Notification" command sequence.
RFFE (option R&S
RTP-K40)
To Next Page
Loading...
