Rohde & Schwarz RTP044 - Page 871

Protocol analysis
R&S
®
RTP
871User Manual 1337.9952.02 ─ 12
"Data pattern"
Searches for a defined data pattern or pattern range.
"NULL frame"
Searches for a null frame, a frame without usable data.
"Time Code"
Searches for a time-code control code. You can define the data pat-
tern of the time code to be searched for.
"ERRORs"
Searches for an enabled error type.
Remote command:
SEARch:TRIGger:SWIRe:TYPE on page 2120
Trigger Control Type
Searches for a specific control type character.
"ANY"
Any control type character
"FCT"
Flow Control Token character
"EOP"
Normal End of Packet character
"EEP"
Error End of Packet character
Remote command:
SEARch:TRIGger:SWIRe:CTYPe on page 2117
Data (Time Code)
Sets the specified data type for the time code to be searched for. The data type setup
consists of the condition and one or two data patterns.
"Condition"
Defines the operator to set a specific data type ("Equal" or "Not
equal") or a data type range.
"Data Min/
Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:SWIRe:TIME:CONDition on page 2119
SEARch:TRIGger:SWIRe:TIME:MAX on page 2120
SEARch:TRIGger:SWIRe:TIME:MIN on page 2120
Data(Data Pattern)
Sets the specified data type for the data pattern to be searched for. The data type
setup consists of the condition and one or two data patterns.
"Condition"
Defines the operator to set a specific data type ("Equal" or "Not
equal") or a data type range.
"Data Min/
Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor, see
Chapter 13.1.7, "Bit pattern editor", on page 519.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
SpaceWire (option R&S RTP-K65)