Protocol analysis
R&S
®
RTP
872User Manual 1337.9952.02 ─ 12
Remote command:
SEARch:TRIGger:SWIRe:DATA:CONDition on page 2118
SEARch:TRIGger:SWIRe:DATA:MAX on page 2118
SEARch:TRIGger:SWIRe:DATA:MIN on page 2118
Parity Error
Checks the parity of every frame and searches for even parity.
Remote command:
SEARch:TRIGger:SWIRe:ERRor:PARity on page 2119
ESC Error
Searches for an escape error.
Remote command:
SEARch:TRIGger:SWIRe:ERRor:ESC on page 2119
13.21.5.2 SpaceWire search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:SWIRe:FCOunt? on page 2120
●
SEARch:RESult:SWIRe:FRAMe<m>:DATA? on page 2121
●
SEARch:RESult:SWIRe:FRAMe<m>:STARt? on page 2121
●
SEARch:RESult:SWIRe:FRAMe<m>:STATe? on page 2121
●
SEARch:RESult:SWIRe:FRAMe<m>:STOP? on page 2122
●
SEARch:RESult:SWIRe:FRAMe<m>:TYPE? on page 2122
13.21.5.3 Searching SpaceWire
Prerequisite: A serial bus is configured for the SpaceWire signal to be decoded and
analyzed.
The search for events is set up in the following way:
1. Press [Search] or tap "Search" > "Setup" in the menu bar.
2. If the dialog box does not contain a search entry, tap the "Add" icon to create one,
as described in "To create a user-defined search" on page 463.
SpaceWire (option R&S
RTP-K65)
To Next Page
Loading...
