Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
972User Manual 1337.9952.02 ─ 12
Select waveform
When a multichannel file is loaded into the arbitrary waveform generator, a dialog
appears to select which waveform from the file is loaded.
Select the waveform and press "Load" to load it into the arbitrary waveform generator.
Remote command:
WGENerator<m>:ARBGen:MULTichannel:NAME on page 2230
WGENerator<m>:ARBGen:MULTichannel:IMPort on page 2230
WGENerator<m>:ARBGen:MULTichannel:OPEN on page 2231
15.1.5.3 Scope waveform
For a scope waveform, the following settings are available:
Signal source
Selects the oscilloscope source, from which the arbitrary signal is loaded.
Remote command:
WGENerator<m>:ARBGen:SELect on page 2232
Load
Loads the waveform from the selected "Signal source".
Remote command:
WGENerator<m>:ARBGen:COPY on page 2230
Setup of the waveform generator
To Next Page
Loading...
