Configuration Guide 802.1X Commands
With this command executed, MAB authentication is initiated after 802.1X authentication fails.
Meanwhile, MAB authentication takes precedence over 802.1X authentication.
The following example sets the order and precedence for authentication.
Ruijie(config-if)# dot1x auth-with-order
Use this command to configure auto-request 802.1X authentication.
Use the no form of this command to restore the default setting.
This function is disabled by default.
Global configuration mode
Enable this function for MAB. If the authentication agent is already in the terminal system, enable it by
clicking.
The following example enables auto-request 802.1X authentication.
Ruijie(config)# dot1x auto-req
Displays the automatic authentication request information.
To Next Page
Loading...
Need help?
General