Configuration Guide 802.1X Commands
4.14 dot1x auto-req packet-num
Use this command to set the number of auto-request authentication packets.
dot1x auto-req packet-num num
The number of auto-request authentication packets in the range from 0 to 1,000,000
The following example sets the number of auto-request authentication packets to 100.
Ruijie(config)# dot1x auto-req packet-num 100
Displays the authentication request information.
4.15 dot1x auto-req req-interval
Use this command to set the auto-request authentication interval.
Use the no form of this command to restore the default setting.
dot1x auto-req req-interval time
no dot1x auto-req req-interval
The auto-request authentication interval, in the range from
10 to 3,600 in the unit of seconds
The default is 30 seconds.
Global configuration mode
The following example sets the auto-request authentication interval to 50 seconds.
To Next Page
Loading...
