Configuration Guide 802.1X Commands
Ruijie(config)# dot1x probe-timer interval 30
4.39 dot1x pseudo source-mac
Use this command to use a virtual MAC address as the source MAC address of the 802.1X packets
sent by the device.
Use the no form of this command to disable the usage of a virtual MAC address as the source MAC
address of the 802.1X packets sent by the device..
no dot1x pseudo source-mac
This function is enabled by default.
Global configuration mode
By default, the device uses its own MAC address as the source MAC address of the EAP packets for
the 802.1X authentication. Some versions of the Ruijie supplicant judge whether the access device is
a Ruijie device based on the source MAC address of the EAP packets. If the access device is a Ruijie
device, the supplicant device performs some private features. Configure this command if you want to
enable these features.
The following example uses the virtual MAC address as the source MAC address of the 802.1X
packets sent by the device:
Ruijie(config)# dot1x pseudo source-mac
To Next Page
Loading...
Need help?
General