Configuration Guide 802.1X Commands
4.40 dot1x re-authentication
Use this command to enable timed re-authentication function.
Use the no form of the command to restore the default setting.
no dot1x re-authentication
This function is disabled by default.
Global configuration mode
This command will re-authenticate the supplicant periodically after he passes the authentication. Use
the show dot1x command to display 802.1X configuration. The default setting is recommended.
The following example enables timed re-authentication function.
Ruijie(config)# dot1x re-authentication
Displays the 802.1X information.
Use this command to set the maximum re-auth attempts.
Use the no form of this command to restore the default setting.
Maximum re-auth attempts. The range is from 1 to 10.
Global configuration mode
To Next Page
Loading...
