Configuration Guide 802.1X Commands
Use this command to specify the maximum number of supplicant re-authentications. Use the show
dot1x command to display 802.1X configuration.
The following example sets the maximum re-auth attempts to 2.
Ruijie(config)# dot1x reauth-max 2
Displays the 802.1X information.
Use this command to enable the second generation SU upgrade function.
Use the no form of this command to restore the default setting.
This function is disabled by default.
Global configuration mode
Redirect to the supplicant software download website through the browser. See Web Authentication
Configuration Guide for details about parameters.
The following example enables the second generation SU upgrade function,
Ruijie(config)# dot1x redirect
4.43 dot1x timeout re-authperiod
Use this command to set the re-authentication interval when re-authentication is enabled.
To Next Page
Loading...
Need help?
General