Ruijie RG-S29 Series

Configuration Guide Global IP-MAC Binding Commands
Description
rate-limit rate
Printing rate of the logging filter of global IPv4 MAC binding. By
default, the rate is 10 logs per minute. The configurable range is from
1 to 120 logs per minute.
Defaults
Logging filter is disabled.
Command
Mode
Global configuration mode
Usage Guide
By default, the rate is 10 logs per minute.
When a logging filter is configured, alert logs are printed if IP packets not containing matched IP
address and MAC address are detected.
When a logging filter is configured, the number of non-printed logs is prompted if the actual printing
rate exceeds the set rate.
The following example enables logging filter:
Configuration
Examples
Ruijie# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)# address-bind binding-filter logging
Ruijie(config)# end
Related
Commands
Command
Description
N/A
N/A
Platform
Description
N/A
7.3 address-bind install
Use this command to enable a binding policy globally. Use the no form of this command to restore the
default setting.
address-bind install
no address-bind install
Parameter
Description
Parameter
Description
N/A
N/A
Defaults
N/A
Command
Mode
Global configuration mode
Usage Guide
If you bind an IP address to a MAC address, run this command to make the installation policy take
effect.