Configuration Guide NFPP Commands
ip-guard attack-threshold
Sets the global attack threshold.
Sets the limit threshold and attack threshold.
Displays the monitored host.
21.17 clear nfpp nd-guard hosts
Use this command to remove the speed limit on the monitored host.
clear nfpp nd-guard hosts [vlan vid] [interface interface-id]
Sets the interface name and number.
This command without any parameter is used to remove speed limit on all monitored hosts.
The following example removes speed limit on interface g0/1 in VLAN 1.
Ruijie# clear nfpp nd-guard hosts vlan 1 interface g0/1
Use this command to clear the NFPP log buffer area.
To Next Page
Loading...
