Command Reference CWMP Commands
Use this command to configure the backup and restoration of the main program and configuration file
of the CPE.
Use the no form of this command to disable this function.
cpe back-up [ delay-time seconds ]
Specifies the delay for backup and restoration of the main program
and configuration file of the CPE, in the range from 30 to 10,000 in
the unit of seconds
The default is 60 seconds.
You can configure the restoration function on a CPE, so that the CPE can restore itself from
exceptions of its main program or configuration file. Then when the CPE fails to connect to the ACS
and breaks away from the NMS after its main program or configuration file is upgraded, the previous
main program or configuration file of the CPE can be restored in time for the ACS to manage the
CPE. This kind of exception is generally caused by delivery of a wrong main program or configuration
file.
The following example disables the backup and restoration of the main program and configuration file
of the CPE.
Ruijie#config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#cwmp
Ruijie(config-cwmp)#no cpe back-up
Ruijie(config-cwmp)#
Displays the current configuration of CWMP.
Displays the running status of CWMP.
To Next Page
Loading...
Need help?
General