Command Reference CWMP Commands
Use this command to enable the CPE backup function.
Use the no form of this command to restore the default setting.
cpe back-up [delay-time seconds]
Sets the backup delay time (30-10,000 seconds).
The default is 60 seconds.
After updrading main programs or configurations, CPE cannot communicate with ACS for wrong
configuration delivery. Use this command to recover the previous programs and configurations.
The following example disables the CPE backup function.
Ruijie#config terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#cwmp
Ruijie(config-cwmp)#no cpe back-up
Ruijie(config-cwmp)#
Use this command to configure the periodic notification function of the CPE.
Use the no form of this command to restore the default setting
cpe inform [ interval seconds ] [ starttime time ]
Specifies the periodical notification interval of the CPE in the range
To Next Page
Loading...
Need help?
General