Command Reference CWMP Commands
Use this command to configure the URL of the CPE to which the ACS will connect.
Use the no form of this command to restore default setting.
Specifies the URL of the CPE.
Use this command to configure the URL of the CPE to which the ACS will connect. If no CPE URL is
manually specified but a dynamic CPE URL is obtained through DHCP, the ACS initiates a
connection to the CPE using the dynamically obtained CPE URL. The URL of the CPE should meet
the following format requirements:
 The URL of the CPE is formatted as http://ip [: port ]/ path.
 The URL of the CPE consists of at most 256 characters.
The following example specifies the URL of the CPE to http://10.10.10.1:7547/acs.
Ruijie#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#cwmp
Ruijie(config-cwmp)#cpe url Hhttp://10.10.10.1:7547/
Ruijie(config-cwmp)#
Displays the current configuration of CWMP.
Displays the running status of CWMP.
Use this command to configure the ACS username to be authenticated for the CPE to connect to the
To Next Page
Loading...
Need help?
General