Command Reference Interface Commands
The following example sets the interval for calculating load on interface GigabitEthernet 0/1 to 180
seconds.
Ruijie(config)# interface gigabitEthernet 0/1
Ruijie(config-if-GigabitEthernet 0/1)# load-interval 180
Use this command to print information on the interface.
logging [ link-updown | error-frame | link-dither ]
Prints the status change information.
Prints the error frame information.
Prints the oscillation information.
This function is enabled by default.
Global configuration mode
The following example prints information on the interface..
Ruijie(config)# logging link-updown
Ruijie(config)# logging error-frame
Ruijie(config)# logging link-dither
To Next Page
Loading...
Need help?
General